Hyper9 Electric car conversion drive System

This is the higher voltage AC motor & controller from NetGain motors. The 9 inch HyPer9 HV AC motor is based on a high efficiency design. The motor is a permanent magnet assisted synchronous reluctance design and holds the highest efficiency rating of IE4+ at 94% motor efficiency. The motor is IP56 sealed. The updated matching controller, is the HyPer-Drive-X144 by SME Group will accept a supply side DC voltage of up to 132 Volts, and will output up to 760 Amps output, with a peak 88kW of power. The permanent magnets are a new design that are manufactured without the use of rare earth elements, but still gain a big efficiency advantage with a powerful 173 lb/ft of torque.

*SME Dash Display is sold separately

This kit includes:
HyPer 9 Motor
SME AC-X1 Controller
35 Pin Connector and Wire Harness
Gigavac GV200-PA Contactor
12 Volt HV Relay

Motor Face: B-Face (Warp Compatible)
Motor Diameter: 9.0 Inches
Motor Case Length: 13.75 Inches
Motor Shaft Length: 2.0 Inches
Motor Shaft to End Length: 15.75 Inches
Motor Type: Permanent Magnet Synchronous Reluctance AC
Weight: 120 lbs
Max Voltage Input: 132
Terminal Stud Size: M8 Inch
Integrated Sensors: Encoder and Temperature
Rated Torque: 173 Lb Ft
Rated Power: 120 HP
Max RPM: 8,000
RPM Sensor: Yes
Drive End Shaft: 1-1/8 Inch with 1/4 Inch Keyway
Accessory End Shaft: (available soon)
Max Efficiency: 0.94
Thermal Cooling: External Heatsink
Max Temperature: 150 Degrees Celsius
Matching Controller Included In Price:

Note: Due to the excessive weight of motors additional freight charges apply. Additional freight charge if no forklift and lift gate service is needed.

Warranty Period: 2 Years